TCRSR CONFIGURATION FILE

DATA INPUT FILE: /Users/rmr/swmain/apps/tcrsr/data/c070924/c070924.dat
DATA OUTPUT FOLDER: /Users/rmr/swmain/apps/tcrsr/data/c070924

# MFR head serial number
HEAD SERIAL NUMBER: 483

# $nside is the half width of the output array.
# The array will have 2*$nside+1 points
BAND1 ARRAY HALF WIDTH: 20
BAND2 ARRAY HALF WIDTH: 50

# $nends are the points from each end of the a array that is used to compute 
# standard deviations and shadow ratio.
GLOBAL END POINTS: 4

# $shadowlimit is the limit for a good sweep.
SHADOWLIMIT: 2.3

#========= SWEEP END POINTS ====================
# Measure the sweep end angles.  The sweep limit angles are named for the 
# band number (1 or 2) and the limit position (fwd or rev = 1 or 2).
# These angles are measured and entered in the configuration file.
# The angles are measured from the horizon down, i.e. degrees below the 
# horizon.
# Angles 11 & 21 are the angles at the forward switch position.
BAND LIMIT ANGLE 11: 6.0
BAND LIMIT ANGLE 12: 5.1
BAND LIMIT ANGLE 21: 0.3
BAND LIMIT ANGLE 22: 0.1

#=========== SWEEP SAMPLE WAIT TIMES ==============================
# We wait for a given number of milliseconds before beginning the sample loop.
SAMPLE WAIT MILLISECS BAND 1: 1470
SAMPLE WAIT MILLISECS BAND 2: 1470

#============= SAMPLE PERIOD MILLISECS ==========================
# After the waiting time the samples are taken with a set millisec delay.
SAMPLE PERIOD MILLISECS BAND 1: 20
SAMPLE PERIOD MILLISECS BAND 2: 20